Wiring an Electric Guitar in Autodesk Inventor

@ClintBrown3D Autodesk Inventor

As part of the AU London class that I recently ran, I have added some voice narrations to the videos that I recorded around wiring up the guitar. I loosely based my wiring on the information shown on Frailin pickups website: https://www.fralinpickups.com/fralin-wiring-diagrams/. Note that I am not an electrical or electronics expert, the workflow I am showing is just to illustrate how “point to point” wiring is done.

Part 1

Below is the part one video, this looks ad adding electrical connectors to parts, so that Inventor’s Wire and Harness environment can recognise them as electrical components, in turn allowing for point to point wiring.

The Next video shows me wiring up the components.

Part 2

Here’s part 2 showing the “Wiring”, the “Segments” (or harness, the bits in blue), as well as fixing a wire that was clashing.

Bonus Round

A YouTuber named Krzysztof Gad published a very similar video to this in 2017, here is his silent video, note that it is 38 minutes long, but well worth a watch!

Comments are closed.

Create a website or blog at WordPress.com

Up ↑

%d bloggers like this: